Journals
  Publication Years
  Keywords
Search within results Open Search
Please wait a minute...
For Selected: Toggle Thumbnails
Patterns of Influences of Shale Oil Horizontal Well Hydraulic Fracturing and Production on Pressure,Stress and Oil Saturation Fields
Ma Xinfang , Wang Qing , Ma He , Wang Yipeng , Yu Huiyong, , Wang Rui
Xinjiang Oil & Gas    2026, 22 (3): 58-66.   DOI: 10.12388/j.issn.1673-2677.2026.03.006
Abstract (73)      PDF (2872KB)(29)       Save

The Jimsar shale oil reservoir is characterized by ultra-low porosity,ultra-low permeability,low crude oil mobility and high reservoir heterogeneity. Consequently,the development of hydraulically fractured horizontal wells is challenged by reservoir energy depletion and unclear oil-water distribution. To address these issues,a hydraulic fracture propagation model coupled with a reservoir numerical simulation model based on the reservoir petrophysical properties is established to investigate the dynamic evolution of three fields (the pressure field,stress field,and oil saturation field) during hydraulic fracturing and subsequent production. The results indicate that the oil saturation around the fractures decreases rapidly after fracturing fluid injection,and it partially recovers during the early production stage,owing to flowback of fracturing fluids and spontaneous imbibition displacement. During hydraulic fracturing,the pressure and minimum horizontal principal stress around the wellbore both increase significantly,whereas they decrease during the production stage. The pressure decline near the wellbore is larger than that in the far-field region,while the reduction in near-wellbore minimum horizontal principal stress is relatively smaller because of the stress concentration induced by fracture opening. The combined effects of fracture opening and fracturing fluid injection result in the deflection of the in-situ stress orientation around the wellbore. This deflection weakens during the early production period but intensifies after long-term production. The findings of this research provide theoretical guidance for understanding the multi-field coupled evolution around horizontal wells during shale oil development and offer a scientific basis for improving the efficiency of shale oil exploitation.

Reference | Related Articles | Metrics
Research on CO2 Matrix Penetration Distance in Tight Reservoirs
MOU Jianye , YAN Xiaolun , ZHANG Shicheng , SHI Lei , LI Dong , MA Xinfang
Xinjiang Oil & Gas    2024, 20 (3): 64-71.   DOI: 10.12388/j.issn.1673-2677.2024.03.008
Abstract (152)      PDF (2240KB)(103)       Save

During depletion recovery of tight oil,the reservoir pressure and production rate decline rapidly. Energy supplement is a necessary measure to enhance oil recovery. CO2 is a common medium used for energy replenishment (CO2 huff and puff,energy recharging by CO2 prepad). The performance of CO2-assisted enhanced oil recovery (EOR) is highly dependent on the penetration distance. Therefore,the penetration distance of CO2 through the matrix of tight reservoirs was investigated via laboratory experiments and numerical simulation. Mass transfer of CO2 involves both convection and diffusion. Firstly,CO2 diffusion experiments were performed using a high-temperature high-pressure reactor and the cores of a tight formation. Based on the experimental results and Fick's diffusion model,the diffusion coefficient of CO2 was obtained. Next,CMG was used to build a model of CO2 convection and diffusion,and extensive numerical simulations were performed to analyze permeability,considering the effect of diffusion and flooding duration on CO2 penetration distance. The results show that the diffusion coefficient is dependent on permeability. The diffusion coefficient ranges from 10-10 to 10-8 m2/s at the permeability level of the target formation. Diffusion and convention both affect the CO2 penetration distance. Yet,the effects of convection are dominant with higher permeability,while those of diffusion are stronger with lower permeability. Permeability is a decisive factor of the matrix penetration of CO2. The CO2 penetration in tight reservoir matrix is rather low and reaches less than 10 m after 60 days.

Reference | Related Articles | Metrics
Research Progress and Development Direction of Hydrofracturing Design Models
ZHANG Shicheng, CHEN Ming, MA Xinfang, ZOU Yushi, GUO Tiankui
Xinjiang Oil & Gas    2021, 17 (3): 67-73.  
Abstract (597)      PDF (2607KB)(368)       Save
Hydrofracturing model is the basis of hydrofracturing design,and also the crux where current bottlenecking problems lie. In order to promote the development of fracturing design models and softwares in China,fracture propagation models,numerical methods and popular commercial softwares for hydrofracturing are systematically analyzed,and their future development orientations are predicted. Research findings show that (1) Planar and complex fracture models are different in application conditions and accuracy. Most commercial softwares are planar fracture models-based,and most complex fracture models are pseudo-three-dimensional ones. (2) It is the focus of fracturing design softwares to develop models with satisfactory accuracy and efficiency. (3) Artificial intelligence data-driven fracture analysis,and fracture parameter inversion based on micro-seismic and fiber optic logging are the development orientation of fracturing design models.
Reference | Related Articles | Metrics